Can you help me figure out a problem with my monitor heater? - monitor ee cb
I have a-30 Toyotomi Laser Heating, and I keep getting the EE "12" (high-limit switch activated) error, even if the fan filter is not in the unit. Any idea what's going on?
Friday, December 18, 2009
Monitor Ee Cb Can You Help Me Figure Out A Problem With My Monitor Heater?
2 comments:
I have a stove Toyotomi. I have this awesome place where all the codes it is and how to fix it. I downloaded and printed all the pages in case the site ever goes down. You should do the same.
http://www.rural-energy.com/publications ...
The error code EE12
The switch to protection against overheating (by the end of the race) is estimated at 195 ° F. They are at the top of the heat
Shield. If the high limit switch is open, the fuel pump stops and the error code displayed on the EE12
Digital display.
Causes:
1. The air flow is blocked to the front or back of the unit.
2. High limit switch is faulty (very rare).
Hope this helps.
Have you tried turning off the power to reset the error code?
Sensor could be bad.
Post a Comment